EUCHNER AS - Manual (Page 25)

Safety Monitors - AS-i Quick Reference - 08/2014 25
3.8 Set outputs of the slaves
With this function the outputs of the slaves can be tested.
1. Press OK-button
2. Select TEST and press OK-button
3. Select AS-I circuit in which is the Slave and press OK-button
4. Press OK-button
5. Select BINARY OUTPUTS and press OK-button
6. Select desired Slave by arrow buttons and press OK-button.
7. Set output by arrow buttons and press OK-button to go to the next output
1 OFF 2 OFF
3 OFF 4 OFF
PROFIBUS
QUICK SETUP
AS-I SAFETY
DIAGNOSIS
SLAVE ADR TOOL
TEST
SETUP
DISP CONTRAST
WARNIG:
OUTPUTS MAY BE
SET AND HOST MAY
LOOSE CONTROL.
AS-I CIRCUIT 1
AS-I CIRCUIT 2
BINARY OUTPUTS
D3…D0
1A - 0 0 0 0
2A - 0 0 0 0
…
SLAVE TEST TOOL
BINARY INPUTS
BINARY OUTPUTS
ANALOG INPUTS
ANALOG OUTPUTS
PARAMETERS