Feiss VS16702 - Manual

IMPORTANT
TURN OFF THE POWER AT THE MAIN FUSE OR
CIRCUIT BREAKER BOX
BEFORE STARTING INSTALLATION
Carefully unpack and identify all parts before assembly. Bulbs
not included.
1. Install mounting plate:
A. Fasten two long machine screws (supplied) onto the
mounting plate (from the side opposite of green grounding
screw head). NOTE: Install onto holes corresponding with
fixture plate mounting holes.
B. Take supply wires from wall outlet box and carefully pass
them through center hole of mounting plate.
C. Install mounting plate onto the outlet box using two
screws supplied with outlet box.
D. Test install fixture plate to make certain about 1/4” (5mm)
of screws protrude outside of fixture plate. If not then
remove fixture plate and adjust screws length accordingly.
Secure screws length by fastening with two hex nuts. Make
certain not to spin screws during fastening.
2. Install anchor (included):
A. Test install fixture plate onto the two long machine
screws. Then while the fixture plate is leveled horizontally,
use a pencil to mark two holes located on the fixture plate.
B. Remove the fixture plate and set aside.
C. Drill marked spots. If drywall or masonry wall then use
1/4" (7 mm) drill bit; if wood wall then use 1/8" (4 mm) drill
bit.
D. Drywall or masonry wall only: Insert plastic anchor into
pre-drilled holes.
3. Connect electrical wires:
A. Connect white fixture wire(s) to white supply wire from
outlet box with wire connector. Connect black fixture
wire(s) to black supply wire from outlet box with wire
connector.
NOTE: Black outlet box wire may be red, round and smooth
and/or have copper conductor. White outlet box wire may be
square and ridged and/or have a silver conductor.
B. Connect fixture ground wire (without plastic insulation)
to ground wire from outlet box (usually with green
insulation) with wire connector.
Note: If there is no supply ground wire at outlet box then
attach fixture ground wire securely onto green grounding
screw located at mounting plate.
IMPORTANT: Never connect ground wire to black or white
supply wires (from outlet box).
4. Install fixture plate:
A. Install fixture plate onto mounting plate by fastening with
two cap nuts.
B. Secure fixture plate onto pre-drilled holes using sheet
metal screws (included).
5. Install fabric shade inside of fixture frame by fastening with
two cap screws.
6. Install bulb (not included). See relamping label located at
socket area for type and maximum allowed wattage.
Assembly Instructions For
VS16702
(E) 12/09
3B
3A
6
4A 4B
5
1C
1D
1A
2
1B