Feiss VS16402 - Manual

IMPORTANT
TURN OFF THE POWER AT THE MAIN FUSE OR CIRCUIT BREAKER BOX
BEFORE STARTING INSTALLATION
Carefully unpack and identify all parts before assembly. Bulbs not included.
1. Install mounting plate:
A. Take supply wires from wall outlet box and carefully pass them through center hole
of mounting plate.
B. Install mounting plate onto the outlet box using two screws supplied with outlet box.
2. Install anchor (included):
A. Test install fixture plate onto the mounting plate. Then while the fixture plate is
leveled horizontally, use a pencil to mark two holes located on the fixture plate.
B. Remove the fixture plate and set aside.
C. Drill marked spots. If drywall or masonry wall then use 1/4" (7 mm) drill bit; if wood
wall then use 1/8" (4 mm) drill bit.
D. Drywall or masonry wall only: Insert plastic anchor into pre-drilled holes.
3. Connect electrical wires:
A. Connect white fixture wire(s) to white supply wire from outlet box with wire
connector. Connect black fixture wire(s) to black supply wire from outlet box with wire
connector.
NOTE: Black outlet box wire may be red, round and smooth and/or have copper
conductor. White outlet box wire may be square and ridged and/or have a silver
conductor.
B. Connect fixture ground wire (without plastic insulation) to ground wire from outlet
box (usually with green insulation) with wire connector.
Note: If there is no supply ground wire at outlet box then attach fixture ground wire
securely onto green grounding screw located at mounting plate.
IMPORTANT: Never connect ground wire to black or white supply wires (from outlet
box).
4. Install fixture plate:
A. Install fixture plate onto mounting plate by fastening with two cap nuts.
B. Secure fixture plate onto pre-drilled holes using sheet metal screws (included).
5. Install glass panels:
A. Gently sit long glass plate at bottom of fixture frame.
B. Gently grabbing onto side glass panel, slip inside of main frame. Make certain bottom
edge of panel sits inside of bottom tabs. Then secure glass panel by bending tabs located
at top. Repeat rest panels.
6. Install type T-10 of medium base light bulb (not included).
IMPORTANT: See relamping label at socket area for maximum allowed wattage.
Assembly Instructions For
VS16402
(E) 12/09
4B
4A
5B
5A
2
3B
3A
1A
6
1B