Feiss WB1479 - Manual

IMPORTANT
TURN OFF THE POWER AT THE MAIN FUSE OR
CIRCUIT BREAKER BOX
BEFORE STARTING INSTALLATION
Carefully unpack and identify all parts before assembly. Bulb
not included.
1. Install anchor (included):
A. Hold mounting plate up against the wall aligning the two
holes in the wall outlet box with appropriate slots in the
mounting plate. Then while the mounting plate is leveled
vertically, use a pen or pencil to mark on the wall the holes
located near each end of mounting plate.
B. Remove the mounting plate and set aside.
C. Drill marked spots. If drywall or masonry wall then use
1/4" (7 mm) drill bit; if wood wall then use 1/8" (4 mm) drill
bit.
D. Drywall or masonry wall only: Insert plastic anchor into
pre-drilled holes.
2. Install mounting plate:
A. Take supply wires from outlet box and carefully pass them
through center hole of mounting plate. Note: the flat surface
of mounting plate must face the wall and the angled rim side
facing toward you.
B. Install mounting plate to outlet box using two screws
supplied with the outlet box.
C. Secure mounting plate onto pre-drilled holes using sheet
metal screws (included).
D. Then Spread electrical wires so that black wires are on
one side of the outlet box and the white wires are on the
other side.
3. Connect electrical wires:
A. Connect white fixture wire to white supply wire from
outlet box with wire connector. Connect black fixture wire
to black supply wire from outlet box with wire connector.
NOTE: Black outlet box wire may be red, round and smooth
and/or have copper conductor. White outlet box wire may be
square and ridged and/or have a silver conductor.
B. Connect fixture ground wire (without plastic insulation) to
ground wire from outlet box (usually with green insulation)
with wire connector.
Note: If there is no supply ground wire at outlet box then
attach fixture ground wire securely onto green grounding
screw located at mounting plate.
IMPORTANT: Never connect ground wire to black or white
supply wires (from outlet box).
4. Install fixture:
A. Hook top of fixture frame onto top edge of mounting
plate.
B. Then secure bottom of fixture frame by fastening set
screw. Use provided hex key to tighten.
5. Install type T-10 of medium base light bulb (not included).
See relamping label at socket area for maximum allowed
wattage.
6. Slide glass shade through top ring until it checks onto bottom
tab.
Assembly Instructions For
WB1479
(E) 11/09
1
5
4B
4A
2A
2B
3
2D
2C
6