Feiss SF190 - Manual

(E) 10/04
ASSEMBLY I NSTRUCTI ONS FOR SF190
M U R R A Y F E I S S
©MURRAY FEI SS I MPORT LLC.
Bulb
(not included)
Socket
Note: Spare crystals enclosed in hardware bag.
Fixture Wire
and Ground Wire
Glass
Shade
Threaded Pipe
Center Pipe
Finial
Hex Nut
Fixture plate
Flat Washer
Crown
Arm
IMPORTANT
TURN OFF POWER AT MAIN FUSE OR
CIRCUIT BREAKER BOX BEFORE
STARTING INSTALLATION
Carefully unpack and identify all parts before assembly.
Bulbs are not included.
1. Thread ground wire and fixture wire through fixture
plate. Screw threaded end of center pipe into fixture plate.
2. Install light bulbs (not included). See relamping label
at socket area for type and maximum allowed wattage.
3. Take threaded pipe and screw into finial. Install finial
onto bottom of glass shade by locking with flat washer
and hex nut from other side. Do not over tighten hex nut.
4. Lay glass shade onto center of crown. Then while
lifting crown above glass shade rim, hook arms onto
every other curls of crown as shown in illustration.
Note: Gently squeeze bottom ends of arm together in
order to slip and hook onto curls. Repeat other arms.
Temporarily lay hooked arms on inside of glass shade.
Set them aside.
5. Follow enclosed “Multiple Standard Installation
Instructions” for electrical and fixture installation onto
ceiling outlet box.
6. Install glass shade and crown: While firmly holding
onto crown, install top end of arms onto hooks located
at fixture plate.
7. Hang all crystal glass parts as shown on drawing.
NOTE: To replace broken crystals or pins extras
are included in hardware bag. To replace broken
crystals open pins, remove crystal, hook new one,
then close back pin. Avoid bending pins into
sharp angle.
1
(4) PCS.
2
(1) PC.
2
1