Feiss FM393 - Manual

1
Installation Instructions for
G P I : ENERAL RODUCT NFORMATION
This product is listed by one of the following
“ ationally
ecognized esting aboratory” N R T L
This product is suitable for damp locations.
This product may be dimmed with a standard incandescent dimmer.
This instruction shows a typical installation.
If necessary, screw the shorter end of the threaded nipple tightly onto the mounting plate.
Secure the mounting plate to the electrical box with two mounting plate screws.
Install the shade to the fixture base and secure them together using the cap nuts.
Connect the fixture to a suitable ground in accordance to local electrical codes.
Connect the white fixture wire to the neutral power line wire with a wire nut.
Connect the black fixture wire to the hot power line wire with a wire nut.
Place the fixture base and washer over the threaded nipple, then secure them in place by fastening the coupler.
Screw the lamps into the sockets. Refer to the label on the lamp socket for Max Wattage information.
Screw the threaded pipe onto the coupler, then place the spacer over the threaded pipe and secure it in place by
tightening the nut.
Place the diffuser over the threaded pipe and secure it in place by tightening the finial.
1
2
1A
3
5
CAUTION - RISK OF FIRE
This product must be installed in accordance with
the applicable installation code by a person familiar
with the construction and operation of the product
and the hazards involved.
Use minimum 90°c supply conductors.
4
1
THREADED NIPPLE
1
6
7
8
5
9
MOUNTING PLATE
2
6
THREADED PIPE
Harrow 2 Light Flush Mount
1.1
FM393
Ceiling
FM393_
1
LAMP
WASHER
COUPLER
DIFFUSOR
FIXTURE BASE
3
9
10
SPACER
NUT
FINIAL
SHADE
10
3
7
8
CAP NUT