Feiss FM406 - Manual

1
Installation Instructions for
G P I : ENERAL RODUCT NFORMATION
This product is listed by one of the following
“ ationally
ecognized esting aboratory” N R T L
This product is suitable for damp locations.
This product may be dimmed with a standard incandescent dimmer.
This instruction shows a typical installation.
Install and secure the threaded studs to the mounting plate using the mounting plate nuts.
Secure the mounting plate to the electrical box with two mounting plate screws.
Connect the fixture to a suitable ground in accordance to local electrical codes.
Connect the white fixture wire to the neutral power line wire with a wire nut.
Connect the black fixture wire to the hot power line wire with a wire nut.
Mount the fixture base and fixture onto the mounting plate studs, then secure them in place by tightening the cap nuts.
Screw the threaded pipe to the bottom of the fixture.
Screw the lamp into the socket. Refer to the label on the lamp socket for Max Wattage information.
Place the shade and washer over the threaded pipe, then secure them in place by tightening the nut.
Place the decorative cup over the threaded pipe and secure it in place by tightening the finial.
1
2
1A
3
CAUTION - RISK OF FIRE
This product must be installed in accordance with
the applicable installation code by a person familiar
with the construction and operation of the product
and the hazards involved.
Use minimum 90°c supply conductors.
4
1
1
6
7
8
5
9
MOUNTING PLATE
2
Arbor Creek 2 Light Flush Mount
1.0
F 406 M
Ceiling
F 406_ M
LAMP
FIXTURE BASE
9
FINIAL
SHADE
10
6
DECORATIVE CUP
THREADED PIPE
WASHER NUT
1
7
8
10
MOUNTING PLATE STUD
MOUNTING PLATE SCREW
MOUNTING PLATE NUT
FIXTURE
CAP NUT
6
6