Feiss FM376 - Manual

Installation Instructions for
Maarid 3 Light Flush Mount
1.0
FM376
CAUTION - RISK OF FIRE
This product requires installation by a qualified electrician.
Before installing be sure to read all instructions and
TURN THE POWER TO THE ELECTRICAL BOX OFF.
Ceiling
FM376_
G P I : ENERAL RODUCT NFORMATION
This product is suitable for damp locations.
This product may be dimmed with a standard incandescent dimmer.
This instruction shows a typical installation.
1
2
1A
3
1
FINIAL SET
7
SHADE
2
FIXTURE BASE
1
MOUNTING PLATE
MOUNTING PLATE SCREW
BLACK WIRE WHITE WIRE
NEUTRAL WIRE HOT WIRE
5 6
THREADED NIPPLE
1
8
WASHER
HEX NUT
CAP NUT
LAMP
NUT
FIXTURE SCREW
4
5
6
7
8
7 7
8
8
Secure the mounting plate to the electrical box with two mounting plate screws, then secure the fixture screws to the mounting plate
using nuts.
Install the lamp by screwing it into the socket. Refer to the label on the lamp socket for Max Wattage information.
Insert the cord through the fixture base and trim the cord leaving enough to make electrical connections.
Connect the fixture to a suitable ground in accordance to local electrical codes.
Connect the white fixture wire to the neutral power line with a wire nut.
Connect the black fixture wire to the hot power line wire with a wire nut.
Install the fixture base onto the mounting plate by placing the fixture onto the fixture screws, then securing it in place using cap nuts.
Install the shade to the fixture base by slipping the threaded nipple through the shade and securing it in place using the washer, hex nut
and finial.