Feiss FM374 - Manual

Assembly Instructions For
2
3
4
5A
5B
6
1
FM374
(E) 5/2012
IMPORTANT
TURN OFF THE POWER AT THE MAIN FUSE OR
CIRCUIT BREAKER BOX
BEFORE STARTING INSTALLATION
Carefully unpack and identify all parts before
assembly. Bulbs not included.
1. Install mounting strap:
A. Gently pull supply wires out from outlet box.
B. Install mounting strap onto the outlet box using
two screws supplied with outlet box. NOTE: The side
with green grounding screw head must face away
from the outlet box.
C. Install threaded pipe by screwing onto center of
mounting strap.
D. Test install fixture plate to make certain about
3/8” (8mm) of thread protrude outside of fixture
plate. If not then remove fixture plate and adjust
threaded pipe length accordingly. Secure threaded
pipe length by fastening with hex nut. Make certain
not to spin pipe during fastening. Place fixture plate
aside.
E. Spread electrical wires so that black wires are on
one side of the outlet box and the white wires are on
the other side.
2. Connect electrical wires:
A. Connect white fixture wire(s) to white supply wire
from outlet box with wire connector. Connect black
fixture wire(s) to black supply wire from outlet box
with wire connector.
NOTE: Black outlet box wire may be red, round and
smooth and/or have copper conductor. White outlet
box wire may be square and ridged and/or have a
silver conductor.
B. Connect fixture ground wire (without plastic
insulation) to ground wire from outlet box (usually
with green insulation) with wire connector.
Note: If there is no supply ground wire at outlet box
then attach fixture ground wire securely onto green
grounding screw located at mounting strap.
IMPORTANT: Never connect ground wire to black or
white supply wires (from outlet box).
3. Install fixture plate. While carefully tucking all
electrical wires inside of fixture plate, install the
fixture plate onto the mounting strap by fastening
with hex nut and then cap nut.
4. Install light bulb (not included). See relamping label
at socket area for type and maximum allowed
wattage.
5. A. Screw the long threaded pipe into coupler located
at bottom of socket assembly. Note correct position
of threaded pipe at illustration.
B. Slip spacer tube and shade through the threaded
pipe until it securely checks into bottom of fixture
plate. Then secure into position by fastening with
washer and finial. IMPORTANT: DO NOT OVER
TIGHTEN.
6. Hang all crystal glass parts as shown on drawing.
NOTE: Replace broken drop or pin by gently bending
open the pin, remove the broken drop or pin, hook
new the one, then close back the pin. Avoid bending
the pin into a sharp angle.