Feiss SF193 - Manual

(E) 10/04
ASSEMBLY INSTRUCTIONS FOR SF193
IMPORTANT
TURN OFF POWER AT MAIN FUSE OR
CIRCUIT BREAKER BOX BEFORE
STARTING INSTALLATION
Carefully unpack and identify all parts
before assembly. Bulbs are not included.
1. Screw center pipe onto fixture plate while
removing any slack in wires in between parts.
2. Install arms.
A. Install upper section of arms onto fixture
plate by fastening with small lock washer and
small hex nut.
B. Install lower section or arms onto pan by
fastening with machine screws.
3. Install a hex nut onto one end of long threaded
pipe leaving about 1/2 in. (13mm) thread
exposed. Screw same end of threaded pipe
into coupler. Tighten hex nut.
4. Slip glass shade up till it checks into bottom of
pan. Then lock into position by fastening with
flat washer and hex nut. Do not over tighten.
5. Slip lower font through same threaded pipe
and lock into place by fastening finial.
6. Install light bulb (not included). See relamping
label located at socket area for type and
maximum allowed wattage.
7. Follow enclosed “Multiple Standard
Installation Instructions” for electrical and
fixture installation onto ceiling outlet box.
Arm
Small Hex Nut
Small Lock Washer
Machine Screw
Fixture Wires &
Ground Wire
Center Pipe
Bulb
(not included)
Pan
Hex Nut
Long Threaded
Pipe
Glass Shade
Flat Washer
Hex Nut
Lower Font
Finial
Fixture Plate
M U R R A Y F E I S S
©MURRAY FEISS IMPORT LLC.