Feiss SF220 - Manual

(E) 4/06
IMPORTANT
TURN OFF THE POWER AT THE MAIN FUSE
OR CIRCUIT BREAKER BOX
BEFORE STARTING INSTALLATION
Carefully unpack and identify all parts before
assembly. Bulb not included.
1. Install center column by screwing securely into
fixture plate.
2. Install a hex nut onto one end of long threaded stud
leaving about 3/8" (10 mm) of thread exposed.
Screw same end of threaded stud into bottom of
socket assembly. Tighten hex nut.
3. Follow enclosed supplement installation
instructions for electrical and fixture installation
onto house outlet box. If you do not have an
outlet box at desired location to attach the fixture
than hire a qualified electrician to create one.
4. Install bulbs (not included). See relamping label
located at socket area for type and maximum
allowed wattage.
5. A . Hang all suspension arms onto hooks located at
fixture plate.
B. Hang crown by hooking onto the suspension arms.
C. Slip glass shade through the installed threaded
stud until it checks inside of crown.
D. Hold glass shade in position by fastening with a
flat washer and hex nut. Do not over tighten since it
will raise the crown further up.
E. Slip break through same threaded stud and lock in
position by fastening with finial.
Fixture Plate
Suspension
Arm
Glass Shade
ASSEMBLY INSTRUCTIONS FOR SF220
5
1
3
2
4
Break
Crown
Threaded Stud
Finial
Bulb
(not included)
Flat Washer
Hex Nut
Center
Column