Feiss SF238 - Manual

(E) 4/07
ASSEMBLY INSTRUCTIONS FOR SF238, SF239
IMPORTANT
TURN OFF THE POWER AT THE MAIN FUSE
OR CIRCUIT BREAKER BOX
BEFORE STARTING INSTALLATION
Socket
Assembly
Bulb
(not included)
Mounting Screws
Shade
Carefully unpack and identify all parts
before assembly. Bulbs are not
included.
1. Take fixture wire and ground wire
exiting above center column and thread
through, fixture plate, lock washer and
hex nut. Lock all together by tightening
hex nut.
2. Install upper section of arms onto
fixture plate by fastening with screw
(short) and small hex nut.
3. Install a hex nut onto one end of long
threaded stud leaving about 3/8" (10
mm) thread exposed. Screw same end
of threaded stud into bottom of socket
assembly. Tighten hex nut.
4. Follow enclosed supplement
installation instructions for electrical
and fixture installation onto house
outlet box. If you do not have an outlet
box at desired location to attach the
fixture than hire a qualified electrician
to create one.
5. Install light bulbs (not included). See
relamping label located near socket
area for type and maximun allowed
wattage.
6. Sit decorative pan on top of glass shade.
Then while holding securely onto the
glass shade, slide through the installed
threaded pipe until pan touches bottom
end of arms. Secure into position by
fastening with a flat washer and hex
nut. Afterward, slip cover and install
finial by screwing onto protruding
threaded pipe.
Pan
Flat Washer
Hex Nut
Finial
Cover
Mounting Plate
Arm
Ball Cap Nuts
Fixture Plate
Screw
(short length)
Small
Lock Washer
Threaded Pipe
Center
Column