Feiss FM306 - Manual

IMPORTANT
TURN OFF THE POWER AT THE MAIN FUSE OR
CIRCUIT BREAKER BOX
BEFORE STARTING INSTALLATION
Carefully unpack and identify all parts before assembly. Bulb
not included.
1. Install center pipe into bottom of socket assembly. Note
correct position of pipe from left diagram.
2. Install brackets onto shade by fastening with rubber washer
and thumb screws from behind.
3. A. Fasten two long machine screws (supplied) into opposite
side of the mounting plate from green grounding screw head.
Leave about 1" (25 mm) of thread exposed from mounting
plate before locking with small hex nuts onto the two
machine screws. Make certain not to spin screws during
fastening of hex nuts.
B. Pass supply wires from the ceiling junction box through
center hole in mounting plate.
C. Attach mounting plate securely to ceiling junction box
with two machine screws (supplied with junction box)
through corresponding slots in mounting plate.
D. At this point, test install pan onto mounting plate by
fastening with two cap nuts. If the two machine screws do
not protrude enough for cap nuts to grab onto or are too
long that does not allow pan to sit flush against ceiling then
must remove pan and adjust the length of screws accordingly.
4. A. Spread the electrical wires so that the black wires are on
one side of the outlet box and the white wires are on the
other side.
B. Electrical connections:
Connect the white wire from the fixture to the white wire of
the outlet box. Connect the black wire from the fixture to
the black wire of the outlet box.
NOTE: Black outlet box wire may be red, round & smooth
and/or have copper conductor. White outlet box wire may be
square & ridged and/or have a silver conductor.
C. Grounding Connection:
Connect fixture ground wire (without insulation) to ground
wire from outlet box (usually with green insulation) with
wire connector (not provided).
IMPORTANT: Never connect ground wire to black or white
power supply wires.
5. Place pan through two machine screws so that it sits flush
against ceiling. Be sure all wires are inside pan. Secure pan to
ceiling by fastening with cap nuts.
6. Install bulb (not included). See relamping label located at
socket area for type and maximum allowed wattage.
7. Install shade onto pan by fastening with square cap and finial.
NOTE: Before tightening finial, make certain studs located at
top end of brackets are checked into corresponding holes in
pan.
Assembly Instructions For
FM306
Mounting Plate
Junction Box Machine
Screw (not supplied)
Long Machine Screws
Ceiling Junction Box
Socket
Assembly
Bulb
(not included)
Supply Wire
Fixture Wires
Shade
Pan
Center Pipe
Bracket
Cap Nuts
(E) 12/4/08
Square Cap
Finial
5
6
1
2
7
4
3