Feiss F2226-3 - Manual

(E) 4/07
ASSEMBLY INSTRUCTIONS FOR F2226/3
IMPORTANT
TURN OFF THE POWER AT THE MAIN FUSE
OR CIRCUIT BREAKER BOX
BEFORE STARTING INSTALLATION
Carefully unpack and identify all parts before assembly. Bulbs are not
included.
1. This fixture can be mounted onto ceiling either as chain hung or flush
mount:
CHAIN HUNG INSTALLATION- Fig. 1:
A. Thread fixture wires through threaded pipe, cover, and upper leaf.
Then install threaded pipe by screwing into top of fixture. Slip cover
and upper leaf through protruding threaded pipe. Lock all together by
fastening with fixture loop.
B. At this point, determine the desired length of chain to hang.
Remove any unwanted links with chain pliers.
C. This fixture is supplied with 2 adjustable chain links. These links
are opened and closed by twisting cylinder on chain link. One
adjustable chain link should be installed onto canopy loop. And
another adjustable chain link installed onto the fixture loop. The
standard chain should be installed in between these 2 threaded chain
links.
D. Take ground wire and weave through above chain links, then
thread through center hole in canopy loop. Repeat with fixture wire
(wire with plastic insulation).
FLUSH INSTALLATION- Fig. 2:
A. Remove and discard canopy loop and threaded pipe from canopy.
B. Install threaded pipe by screwing into top of fixture.
C. Thread fixture wires through cover, canopy leaf, canopy, lock
washer, and hex nut. Lock all together on top of fixture by tightening
hex nut onto protruding threaded pipe.
2. Cut excess wires leaving only 6" (15 cm) length of wires above
canopy. Split fixture wire into two strands. Then strip off
3/4"(19mm) of outer plastic insulation.
3. Follow enclosed supplement installation instructions for electrical and
fixture installation onto house outlet box. If you do not have an outlet
box at desired location to attach the fixture than hire a qualified
electrician to create one.
4. Slip candle tube over sockets.
5. Install bulbs (not included). See relamping label located near socket
area for type and maximum allowed wattage.
6. Hang all crystal glass parts as shown on drawing. NOTE: To replace
broken crystals extras are included in hardware bag. Replace by
gently bending open pin, remove broken crystal, hook new one, then
close back pin. Avoid bending pin into sharp angle.
Fixture Loop
Fixture
Loop
Chain
FIG.1
CHAIN HUNG
INSTALLATION
FIG.2
FLUSH MOUNT
INSTALLATION
Upper Leaf
Upper Leaf
Cover
Cover
Threaded
Pipe
Threaded Pipe
Canopy (Fixture Plate)
Canopy
(Fixture Plate)
Ball Cap Nut
Ball Cap Nut
Canopy Loop
Canopy
Loop
Hex Nut Canopy
Threaded
Pipe
Candle Tube
Adjustable
Chain Link
Adjustable
Chain Link
Bulb
(not included)
Socket
Lock Washer
2
3 1
4
3
3
1 2 3 4