Feiss F2221-4 - Manual

(E) 4/07
ASSEMBLY INSTRUCTIONS FOR F2221/4
IMPORTANT
TURN OFF THE POWER AT THE MAIN FUSE
OR CIRCUIT BREAKER BOX BEFORE STARTING INSTALLATION
Bulb
(not included)
Canopy
(Fixture Plate)
Canopy Loop
Ball Cap Nut
Threaded Pipe
Glass Shade
Carefully unpack and identify all parts before assembly.
Bulbs are not included.
1. Screw threaded pipe securely into a finial. Then slip the same
threaded pipe through cap and center plate. Lock all together
by fastening with another finial from above.
2. This fixture can be mounted onto ceiling either as chain hung
or flush mount:
CHAIN HUNG INSTALLATION- Fig. 1:
A. Take fixture wire (with plastic insulation) and ground wire
and thread through fixture loop. Then install loop onto
threaded pipe located at top of fixture.
B. This fixture is supplied with 2 threaded chain links. These
links are opened and closed by twisting cylinder on chain link.
One threaded chain link should be installed onto canopy loop
and the other should be installed onto fixture loop. The
standard chain should be installed in between these 2 threaded
chain links.
C. Determine the desired length of chain to hang. Remove any
unwanted links with chain plier.
D. Take ground wire and weave through above chain links,
then thread through center hole in canopy loop. Repeat with
fixture wire (wire with plastic insulation).
FLUSH MOUNT INSTALLATION- Fig. 2:
A. Remove and discard canopy loop and threaded pipe from
fixture plate.
B. Thread ground wire and fixture wire through fixture plate,
lock washer, and hex nut. Lock all together on top of fixture by
tightening hex nut onto threaded pipe.
3. Cut excess wires leaving only 6" (15cm) length of wires above
canopy. Split fixture wire into two strands. Then strip off 3/4"
(19mm) of outer plastic insulation.
4. Follow enclosed “Multiple Standard Installation Instructions”
for electrical and fixture installation onto ceiling outlet box.
NOTE: Before starting wire connection, enlist a helper to
support the fixture, or make a hook from a wire coat hanger
and temporarily suspend the fixture from mounting plate
5. Place Shade over threaded socket then spacer tube and secure
with counter ring, using supplied wrench.
6. Install light bulbs (not included). See label located at socket
area for type and maximum allowed wattage.
Finial (plain)
Lock Washer
Center Plate
Ball Cap Nut
Fixture Wire
& Ground Wire
Fixture Wire
& Ground Wire
Short
Threaded Pipe
Canopy Loop
FIG. 2 FLUSH MOUNT
INSTALLATION
FIG. 1 CHAIN HUNG
INSTALLATION
Fixture Plate
Mounting Screws Mounting Plate
Threaded
Chain Link
Threaded
Chain Link
Chain
Fixture Loop
Wrench
Spacer Tube
Counter Ring
Socket
Hex Nut
Cap
Finial (decorative)