Feiss F1882-5 - Manual

(E) REV 3/05
ASSEMBLY I NSTRUCTI ONS FOR F1882/5
M U R R A Y F E I S S
©MURRAY FEI SS I MPORT CORP .
Bulb
(not included)
Socket
FIG: 1 CHAIN HUNG INSTALLATION
FIG: 2 FLUSH MOUNT
INSTALLATION
Mounting Plate
Machine Screws
Note: Spare crystals enclosed in hardware bag.
Fixture Wire
and Ground Wire
Fixture Loop
Threaded
Chain Link
Fixture Plate
Canopy Loop
Ball Cap
Nuts
Chain
Threaded
Chain Link
Candle Tube
Canopy
Loop
Lock Washer &
Hex Nut
Fixture Plate
Ball Cap Nut
Canopy Leaf
Short
Threaded
Pipe
1 2 3 4 5 6
4
4
3
3
1
6
5
1 pc. 1 pc. 10 pc. 10 pc. 5 pc. 20 pc.
Glass Shade
Fitter
Bottom Assembly
Fixture Wires
IMPORTANT
TURN OFF POWER AT MAIN FUSE OR CIRCUIT
BREAKER BOX BEFORE STARTING INSTALLATION
Carefully unpack and identify all parts before assembly.
Bulbs are not included.
1. Install bottom assembly by screwing into bottom of fixture.
2. Place candle tubes over candelabra sockets and screw bulbs
(not included) into sockets to secure. See relamping label on candle
tube for type and maximum allowed wattage.
3. Hang all crystal glass parts as shown on drawing.
NOTE: To replace broken crystals or pins extras are included in
hardware bag. To replace broken crystals open pins, remove crystal,
hook new one, then close back pin. Avoid bending pins into
sharp angle.
4. This fixture can be mounted onto ceiling either as chain hung
or flush mount:
CHAIN HUNG INSTALLATION- Fig. 1:
A. Take fixture wire (with plastic insulation) and ground wire and
thread through fixture loop. Then install loop onto threaded pipe
located at top of fixture.
B. This fixture is supplied with 2 threaded chain links. These links
are opened and closed by twisting cylinder on chain link. One
threaded chain link should be installed onto canopy loop and the
other should be installed onto fixture loop. The standard chain should
be installed in between these 2 threaded chain links.
C. Determine the desired length of chain to hang. Remove any
unwanted links with chain plier.
D. Take ground wire and weave through above chain links, then
thread through center hole in canopy loop. Repeat with fixture
wire (wire with plastic insulation).
FLUSH MOUNT INSTALLATION- Fig. 2:
A. Remove and discard canopy loop and threaded pipe from
fixture plate.
B. Thread ground wire and fixture wire through fixture plate,
lock washer, and hex nut. Lock all together on top of fixture by
tightening hex nut onto threaded pipe.
5. Cut excess wires leaving only 6" (15cm) length of wires above
canopy. Split fixture wire into two strands. Then strip off 3/4"
(19mm) of outer plastic insulation.
6. Follow enclosed “Multiple Standard Installation Instructions”
for electrical and fixture installation onto ceiling outlet box.
NOTE: Before starting wire connection, enlist a helper to support
the fixture, or make a hook from a wire coat hanger and temporarily
suspend the fixture from mounting plate.
7. Install glass shade by inserting into fitter located at center of fixture.
Make certain it sits securely inside.