Feiss F1931-3 - Manual

(E) 10/04
ASSEMBLY I NSTRUCTI ONS FOR F1931/3
M U R R A Y F E I S S
© MURRAY FEI SS I MPORT LLC.
IMPORTANT
TURN OFF THE POWER AT THE MAIN FUSE
OR CIRCUIT BREAKER BOX
BEFORE STARTING INSTALLATION
Carefully unpack and identify all
parts before assembly. Bulbs are not
included.
1. Thread fixture wires and ground wire,
exiting above socket assembly, through
center column. Then screw center column
into socket assembly.
2. Install arms:
A. Install upper section of arms onto upper
center body by fastening with small lock
washer and hex nut from inside.
B. Install lower section of arms onto lower
center body by fastening with cap screw.
3. Thread fixture wires and ground wire,
exiting above upper center body, through top
assembly. Then screw top assembly into
upper center body.
4. Screw threaded pipe into bottom of socket
assembly. Note correct position of threaded
pipe at illustration.
5. Sit ring onto glass shade and then slip them
through threaded pipe. Lock them into
position by fastening with washer and hex
nut. Do not over tighten.
6. Slip font and fasten finial onto threaded
pipe.
7. Install bulbs (not included). See
relamping label located at socket area
for type and maximum allowed wattage.
8. Follow enclosed “Chain Suspended
Fixture Installation Instructions” for
electrical and fixture installation onto
ceiling outlet box.
Top Assembly
Small Lock Washer &
Small Hex Nut
Arm
Cap Screw
Bulb
(not included)
Ring
Glass Shade
Washer
Hex Nut
Font
Finial
Fixture Wire &
Ground Wire
Upper Center Body
Center Column
Lower Center Body
Socket Assembly
Threaded Pipe