Feiss F1886-3 - Manual

(E) 04/04
ASSEMBLY I NSTRUCTI ONS FOR F1886/3
M U R R A Y F E I S S
©MURRAY FEI SS I MPORT CORP.
27 1/2"
(70 cm) 39 1/2
(100 cm) 51 1/2
(131 cm)
63 1/2
(160 cm)
75 1/2
(192 cm)
87 1/2
(222 cm)
Fixture wire
and Ground Wire
Canopy
Ball Cap Nuts
Mounting Plate
Machine Screw
Swivel
Short Threaded Pipe
Stem (S)
5(-12" Long)
Fixture Coupler
Glass Shade
Counter Ring
Check Ring
Bulb (not included)
Carefully unpack and identify all parts before assembly. Bulbs are not included.
1. Remove counter rings and check ring from sockets.
2. Install shades onto fitters by fastening back check ring (with smaller opening side facing down)
and counter ring onto threaded sockets.
3. Install bulbs (Not included). See relamping label located at socket area for type and maximum
allowed wattage.
STEM HUNG INSTALLATION:
A. Choose desired installation height from dimensions shown in above diagram. Thread fixture wire
through each stem to be used. Please note correct position of stems from left diagram. Screw all
stems together until secure. Screw bottom stem into fixture coupler until secure.
B. Measure 6" of wire from end of canopy and cut off remaining wire. Split wires and strip off 3/4"
of insulation from each end.
C. Follow enclosed ”Fixture installation instructions” for electrical and fixture installation onto
ceiling outlet box.
IMPORTANT TURN OFF THE POWER AT THE MAIN FUSE
OR CIRCUIT BREAKER BOX BEFORE STARTING INSTALLATION
Fitter