Feiss F2479 - Manual

IMPORTANT
TURN OFF THE POWER AT THE MAIN FUSE OR
CIRCUIT BREAKER BOX
BEFORE STARTING INSTALLATION
Carefully unpack and identify all parts before assembly. Bulbs
not included.
1. Turn arms so they are equally spaced apart from each other.
2. A. Install a hex nut onto one end of theshort threaded pipe
leaving about 3/8" (10mm) of thread exposed. Then install same
end of pipe by screwing onto top of fixture. Tighten hex nut.
B. Slip small notched cover and fixture loop through fixture
wires.
C. Install the small notched cover on top of fixture, making
certain arms are locked onto it’s notches, by fastening with
fixture loop.
D. Install a hex nut onto one end of short threaded pipe
leaving about 3/8" (10mm) of thread exposed. Then install same
end of pipe by screwing onto bottom of fixture. Tighten hex
nut.
E. Slip large notched cover through the installed threaded pipe
and secure by fastening with finial. Make certain arms are
locked onto it’s notches before tightening finial.
3. Follow enclosed supplement installation instructions for
electrical and fixture installation onto house outlet box. If you
do not have an outlet box at desired location to attach the
fixture then hire a qualified electrician to create one.
IMPORTANT: WHEN FOLLOWING SUPPLEMENT
INSTRUCTIONS STEP #6, MAKE CERTAIN TO SLIDE
CRYSTAL BOBECHE (IN BETWEEN COLLAR RING AND
CANOPY) DOWN THE CHAIN. See above illustration.
4. A. Install crystal bobeche by slipping through sockets.
B. Install candle tube by slipping through sockets.
C. Install type-B, candelabra base, of 60 Watt maximum bulbs
(not included).
5. Hang all crystal glass parts as shown on drawing.
NOTE: To replace broken crystal or pin, extras are included in
hardware bag. Replace by gently bending open pin, remove
broken crystal or pin, hook new one, then close back pin. Avoid
bending pin into sharp angle.
Assembly Instructions For
F2479/8+4
(E) 12/09
S Hook
Head Pin
Bowtie pin
PIN
DESCRIPTION
12
11
10
9
8
7
7
7
6
5
4
3
1
PIN PART
12
6
6
Extra PIN
Qty.
2
10 9 8 7 6 5 4 3 2
1 1 1
X12 X4 X4
1
X8 X8
2
6 bead
8 2 1 1
X8 X8 X8 X32
10 bead 12 bead
Extra
Required X1
1 12 11
2 1
X8 X1
Small Notched Cover
Short Threaded Pipe
Large Notched Cover
Finial
Fixture Loop
Arm