Feiss F2110-8+4+4 - Manual

(E) 12/13
ASSEMBLY INSTRUCTIONS FOR F2110/8+4+4
3
(1) PC.
2 1
(56) PC. (1) PC.
IMPORTANT:
TURN OFF THE POWER AT THE MAIN
FUSE OR CIRCUIT BREAKER BOX
BEFORE STARTING INSTALLATION.
Carefully unpack and identify all parts
before assembly. Bulb not included.
1. A. Spread open arms so they are evenly
spaced to each other.
B. Screw threaded pipe into coupler
located at bottom section of center body.
Then slip notched cap in order to lock arms
into position. Fasten with small finial.
2. Install fixture loop by screwing onto top of
fixture.
3. Follow enclosed supplement installation
instructions for electrical and fixture
installation onto house outlet box. If you do
not have an outlet box at desired location to
attach the fixture than hire a qualified
electrician to create one.
4. Install threaded stud into cap nut. Then
slip the threaded stud from above through
round plate. Lock them into position by
fastening with a lock washer and hex nut
from below. Install large finial by
screwing onto the protruding threaded stud.
5. Slip candle tube over sockets.
6. Install bulbs (not included). See relamping
label located near socket area for type and
maximum allowed wattage.
7. Hang all crystal glass parts as shown on
drawing. NOTE: To replace broken
crystals extras are included in hardware
bag. Replace by gently bending open pin,
remove broken crystal, hook new one, then
close back pin. Avoid bending pin into
sharp angle.
NOTE: Spare crystals enclosed in hardware bags.
Threaded
Pipe
Threaded
Stud
Cap Nut
Notched
Cap
Fixture wire and
Ground Wire
Bulb
(not included)
Large Finial
Small Finial
Fixture Loop
Candle Tube
Socket
Center
Pipe
Hex Nut
Flat Washer
1
2
3