Feiss F2461 - Manual

IMPORTANT
TURN OFF THE POWER AT THE MAIN FUSE OR
CIRCUIT BREAKER BOX
BEFORE STARTING INSTALLATION
Carefully unpack and identify all parts before assembly. Bulbs not
included.
1. A. Slip center pipe through fixture wires and then secure by
screwing onto top of middle assembly.
B. Slip upper assembly through fixture wires and then secure by
screwing onto top of center pipe.
2. Follow enclosed supplement installation instructions for electrical
and fixture installation onto house outlet box. If you do not have
an outlet box at desired location to attach the fixture than hire a
qualified electrician to create one.
3. Turn arms so they are equally spaced apart from each other.
4. Install lower assembly by screwing onto bottom of middle
assembly.
5. A. Install candle tube by slipping through sockets.
B. Install type-B, candelabra base, of 60 Watt maximum bulbs (not
included).
6. Hang all crystal glass parts as shown on drawing.
NOTE:
A. For easier installation of crystal chains #3, hook all chains first
onto the lower assembly and then proceed to hook onto the
middle assembly.
B. For easier installation of crystal chains #4, hook all chains first
onto the upper assembly and then proceed to hook onto the
middle assembly.
C. To replace broken crystal or pin, extras are included in
hardware bag. Replace by gently bending open pin, remove broken
crystal or pin, hook new one, then close back pin. Avoid bending
pin into sharp angle.
Assembly Instructions For
F2461/6
Middle
Assembly
Bulb
(not included)
(E) 5/09
Candle
Tube
Arm
Center Pipe
Lower
Assembly
Upper Assembly
Socket
3
1
2
4
2
PIN PART
2
12
24
Extra PIN
Qty.
1
X1 Required
Extra 3
X24
4 3
X24 X34
Rectangular
Crystal Hook
Small Bead
Hook
PIN
DESCRIPTION
1 4 3 2
NOTE:
SMALLER
RECTANGULAR
CRYSTAL MUST BE
INSTALLED AT TOP