Feiss F2517 - Manual

IMPORTANT
TURN OFF THE POWER AT THE MAIN FUSE OR CIRCUIT
BREAKER BOX
BEFORE STARTING INSTALLATION
Carefully unpack and identify all parts before assembly. Bulbs not
included.
1. A. Tilt one side of upper frame and insert below mounting tab
located at one end of the upper ring. Then bring down the other
end of upper frame and locate below opposite mounting tab. See fig.
1.
B. Secure upper frame onto mounting tabs by fastening with round
washer and thumb screws.
2. Slip center column through fixture wires, which are located above
the top coupler. Then while gently pulling wires from above, install
the column by screwing securely onto the coupler.
3. Install cover onto top of center column by fastening with finial.
NOTE: Place fixture wires onto notch before closing the cover onto
the column.
4. Attach Chains:
A. Open adjustable chain links by turning small round tube at one
side.
B. Hook chain onto open adjustable chain link. Then attach adjustable
chain link onto loop located at fixture plate. Close adjustable chain
link by turning back small round tube.
C. Repeat other side.
D. At this point determine the desired length of chains to hang.
Remove any unwanted chain links. Additional chains can be purchased
through your local Murray Feiss retailer.
E. Hook another open adjustable chain link at bottom of each chain.
Then attach adjustable chain links onto loop located at top of fixture
arm curls. Close adjustable chain links by turning back small round
tube.
5. Take ground wire (without plastic insulation) and weave through
above chain links. Then thread through hole in fixture plate loop.
Repeat with fixture wires (with plastic insulation).
6. Cut excess fixture and ground wires leaving only 6" (15 cm) length
above canopy. Split the fixture wires into two strands. Then strip 3/4"
(19 mm) of outer plastic insulation.
7. Follow enclosed supplement installation instructions for electrical
and fixture installation onto house outlet box. If you do not have an
outlet box at desired location to attach the fixture then hire a
qualified electrician to create one.
8. Install finial by screwing onto bottom of fixture.
9. Slip tube over sockets. And then slip candle over tube.
Note: Deeper hollow section of candle must be located at bottom.
10. Install bulb (not included). See relamping label located at socket area
for type and maximum allowed wattage.
Assembly Instructions For
F2517/6
(E) 11/09
8
Fig. 1
9
10
2
3
1
7 6
4 5