Feiss F2304 - Manual

(E) 9/07
IMPORTANT
TURN OFF THE POWER AT THE MAIN FUSE
OR CIRCUIT BREAKER BOX
BEFORE STARTING INSTALLATION
Carefully unpack and identify all parts before assembly.
Bulb not included.
1. Install upper frame:
A. Have one person, while holding securely, lower the
upper frame onto main frame. During this process,
have another person gently tuck slack of wires on
each side of wire housing.
B. Once all wires are safely tucked and upper frame is
sitting properly on top of wire housing, then secure
frames together by fastening with two screws on each
side.
2. Attach Chains:
A. Open adjustable chain links by turning small round
tube at one side.
B. Hook chain onto open adjustable chain link. Then
attach adjustable chain link onto loop located at
fixture plate. Close adjustable chain link by turning
back small round tube.
C. Repeat other side.
D. At this point determine the desired length of chains
to hang. Remove any unwanted chain links by
following diagram A. Additional chains can be
purchased through your local Murray Feiss retailer.
E. Hook another open adjustable chain link at bottom
of each chain. Then attach adjustable chain links onto
loop located at top of fixture arm curls. Close
adjustable chain links by turning back small round
tube.
3. Take ground wire (without plastic insulation) and
weave through above chain links. Then thread through
hole in fixture plate loop. Repeat with fixture wires
(with plastic insulation).
4. Follow enclosed “Multiple Standard Installation
Instructions” for electrical and fixture installation
onto ceiling outlet box.
5. Place candle tubes over candelabra sockets and screw
bulbs (not included) into sockets to secure. See
relamping label on candle tube or type and maximum
allowed wattage.
6. Hang all crystal glass parts as shown on drawing.
NOTE: To replace broken crystals extras are included
in hardware bag. Replace by gently bending open pins,
remove broken crystal, hook new one, then close
back pins. Avoid bending pins into sharp angle.
Adjastable
Chain Link
Chain
Bulb
(not included)
Adjastable
Chain Link
Upper Frame
Screw
Assembly Instructions For
Socket Wires
Candle
Tube
Ball
Cap Nut
Fixture Plate
6 pcs. 16 pcs. 2 pcs.
F2304/6
2 3 1
1
2
3
2
2
3
2