Feiss F2947-8 - Manual

1
Installation Instructions for
Soros 8 Light Chandelier
1.0
F2947-8
Chandelier
F2947/8_
G P I : ENERAL RODUCT NFORMATION
This product is listed by one of the following
“ ationally
ecognized esting aboratory” N R T L
This product is suitable for dry locations only.
This product may be dimmed with a standard incandescent dimmer.
1A
CAUTION - RISK OF FIRE
This product must be installed in accordance with
the applicable installation code by a person familiar
with the construction and operation of the product
and the hazards involved.
Use minimum 90°c supply conductors.
1
2
3
4
5
6
7
8
9
CAP NUT
FIXTURE
LOOP
DECORATIVE
CUP
MOUNTING PLATE
MOUNTING PLATE SCREW
MOUNTING PLATE STUD
NUT
ANCHOR
ANCHOR SCREW
CANDLE
FOLLOWER
CANDLE
TUBE
Thread the two mounting studs into the mounting plate and secure them using the nuts.
Align the anchors with the mounting plate holes and install them by pushing them into the ceiling.
Secure the mounting plate to the electrical box with two mounting plate screws provided with electrical box.
Screw the anchor screws into the anchors.
Install the candle tubes by slipping them through the sockets.
Install the candle followers by placing them on top of the candle tubes.
Screw the lamps into the sockets. Refer to the label on the lamp socket for Max Wattage information.
Determine the height of the fixture with the provided stems and washers, then assemble them by screwing them together.
Place the stem cup on top of the stem assembly and secure it in place by tightening the fixture loop.
Feed the fixture wires through the stems, place the decorative cup onto the top of fixture, and secure it by screwing the stem assembly
onto the fixture.
Install the decorative strands by hooking them to the top and bottom of the fixture as shown on drawing.
Open the quick link and secure it onto the canopy and fixture loop by closing it, then feed the fixture wires through the
quick link and canopy.
Connect the fixture to a suitable ground in accordance to local electrical codes.
Connect the white fixture wire (square and/or rigid) to the neutral power line wire with a wire nut.
Connect the black fixture wire (round and/or smooth) to the hot power line wire with a wire nut.
Neatly place all the wires into the electrical box, mount the fixture base onto the mounting plate studs, and secure it with the cap nuts.
10
11
12
13
14
15
16
1
10
16 16
8
8
8 8 9
12