Feiss P1137 - Manual

IMPORTANT
TURN OFF THE POWER AT THE MAIN FUSE OR
CIRCUIT BREAKER BOX
BEFORE STARTING INSTALLATION
Carefully unpack and identify all parts before assembly.
Bulb not included.
1. Install stems:
A. Choose desired installation height from dimensions shown in
above diagram. Thread fixture wires through each stems to be
used. Note correct position of stems from left diagram. Screw all
stem together until secure.
B. Pass fixture wires through swivel in canopy and screw top end
of stem assembly into swivel.
2. Follow enclosed supplement installation instructions for electrical
and fixture installation onto house outlet box. If you do not have
an outlet box at desired location to attach the fixture than hire a
qualified electrician to create one.
3. A. Install bulb (not included). See relamping label located near
socket area for type and maximum allowed wattage.
NOTE: Make certain not to handle lamp with bare hand since this
will cause lamp to shatter at high heat. Handle with clean soft
cloth.
B. Install glass dome by screwing onto socket.
4. Install harp by securely fastening with thumb screws.
5. A. Place metal ring onto glass plate. Then place shade. And then
place another ring on top of shade.
B. While holding firmly onto glass plate, install the assembled
parts onto harp by fastening with finial.
Assembly Instructions For
P1137
Socket
Bulb
(not included)
Glass Dome
Stems
Shade
Canopy
(Fixture Plate)
Cap Nuts
(E) 4/08
Swivel
Glass Plate
Thumb Screw
Metal Ring
Metal Ring
Harp
Finial
50-1/4"
38-1/4"
44-1/4"
32-1/4"
20-1/4"
26-1/4"
8-1/4"
14-1/4"
1
4
2
3
5