Feiss P1283 - Manual

1
Installation Instructions for
Cadence 2 Light Mini Pendant
1.0
P1283
Pendant
P1283_
G P I : ENERAL RODUCT NFORMATION
This product is listed by one of the following
“ ationally
ecognized esting aboratory” N R T L
This product is suitable for dry locations only.
This product may be dimmed with a standard incandescent dimmer.
This instruction shows a typical installation.
Secure the mounting plate to the electrical box with two mounting plate screws.
Screw the lamp into the socket. Refer to the label on the lamp socket for Max Wattage information.
Install the glass shade by aligning it with the fixture base, then using the thumb screws to secure them together.
Determine the wanted height of the fixture, open a quick link, and remove a portion of the chain by opening a link with pliers.
Screw the lower loop onto the fixture base and connect the chain to the lower loop with the bigger quick link.
Install the open quick link onto the upper loop and secure it by closing it.
Weave the cord through the chain and canopy. Trim the cord leaving enough to make electrical connections.
Connect the fixture to a suitable ground in accordance to local electrical codes.
Connect the white fixture wire (square and/or rigid) to the neutral power line wire with a wire nut.
Connect the black fixture wire (round and/or smooth) to the hot power line wire with a wire nut.
Neatly place all the wires into the electrical box, place the canopy onto the ceiling, and secure it in place with the two ball
nuts.
1
2
3
4
1A
CAUTION - RISK OF FIRE
This product must be installed in accordance with
the applicable installation code by a person familiar
with the construction and operation of the product
and the hazards involved.
Use minimum 90°c supply conductors.
LAMP
THUMB SCREW
GLASS SHADE
3
QUICK LINK
LOWER LOOP
CHAIN
FIXTURE BASE
3
2
5
5
BALL CAP NUT
1
6
7
8
9
10
11
UPPER LOOP
CANOPY
6
11