Feiss P1178 User Manual
P1178, Assembly instructions for
IMPORTANT
TURN OFF THE POWER AT THE MAIN FUSE OR
CIRCUIT BREAKER BOX
BEFORE STARTING INSTALLATION
Carefully unpack and identify all parts before
assembly.
Bulbs not included.
1. Follow enclosed supplement installation instructions for
electrical and fixture installation onto house outlet box. If
you do not have an outlet box at desired location to attach
the fixture than hire a qualified electrician to create one.
IMPORTANT: WHEN FOLLOWING SUPPLEMENT
INSTRUCTIONS STEP #6, MAKE CERTAIN TO SLIDE
DECORATIVE BOBECHE (IN BETWEEN COLLAR RING
AND CANOPY) DOWN THE CHAIN. See above
illustration.
2. Install candelabra base, of 60 Watt maximum bulb (not
included).
3. Slip outer assembly through inner assembly, and secure
them at top section by fastening with ball cap screws.
4. Install lower assembly by hooking onto finial. NOTE: Bend
tight open hook in order to prevent from getting loose.
5. Hang all crystal glass parts as shown on drawing.
NOTE:
A. For easier installation of crystal chains #3, hook all
chains first onto the lower assembly and then proceed to
hook onto the outer assembly.
B. To replace broken crystal or pin, extras are included in
hardware bag. Replace by gently bending open pin, remove
broken crystal or pin, hook new one, then close back pin.
Avoid bending pin into sharp angle.
Assembly Instructions For
P1178
Outer
Assembly
Bulb
(not included)
(E) 5/29/09
Inner Assembly
Lower
Assembly
Ball
Cap Screw
2
7
8
6
5
4
1
3
Extra
1
1
1
x 6
x 1
2
1
3
x 6
Require
d
FACTORY INSTALLED
4
14mm
6
4
2
4
12mm
4
26mm
8
22mm
18mm
5
6
7
Used on
# 5, 6, 7, 8
12
8
4
S Hook
4
Extra PIN
Qty.
PIN
PART
PIN
DESCRIPTION
Rectangular
Crystal Hook
4
Used on # 4
Small Bead
Hook