Feiss P1120 - Manual

(E) 10/07
IMPORTANT
TURN OFF THE POWER AT THE MAIN FUSE OR CIRCUIT
BREAKER BOX BEFORE STARTING INSTALLATION
Carefully unpack and identify all parts before assembly. Bulb not included.
1. Install stems:
A. Choose desired installation height from any combination of stems
provided. NOTE: Additional stems can be purchased to increase installation
height. Do not add more stems than will allow 6" (15 cm) of fixture wires
above canopy. Thread fixture wires through each stems to be used. Screw
stems together until secure. Screw stem assembly into top of fixture until
secure. NOTE: This fixture can be installed without any stems for direct
mount onto canopy.
B. Screw swivel securely onto top end of stem assembly (or top end of
fixture for without stem installation).
2. Measure 6” of wire from end of fixture plate and cut off remaining wire.
Split wires and strip off 3/4” of insulation from each end.
3. Follow enclosed “Multiple Standard Installation Instructions” for electrical
and fixture installation onto ceiling outlet box.
4. Install glass shade onto fitters by fastening with spacer tube and counter
ring.
5. Install bulbs (not included). See relamping label located near socket area for
type and maximum allowed wattage.
Assembly Instructions For
P1120
Cap Nut
Mounting Plate
Canopy
(Fixture Plate)
Stems
(3) 12 in. long
(1) 6 in. long
Socket
Fitter
Shade
Bulb
(not included)
Swivel
Stem
(with leaf)
Spacer Tube
Counter Rng
22"
10"
52"
40"
46"
34"
64"
58 "
28"