Feiss P1146 - Manual

(E) 4/08
IMPORTANT
TURN OFF THE POWER AT THE MAIN FUSE OR CIRCUIT BREAKER
BOX BEFORE STARTING INSTALLATION
Carefully unpack and identify all parts before assembly. Bulb not included.
1. A. Insert glass tube inside of fixture. Then install glass shade onto bottom of fixture
by holding with cover and fastening with short screws. Note: Make certain wire
connector protrude outside of cover before fastening screws.
B. Install socket assembly onto threaded pipe which protrude below the cover by
fastening with a lock washer and hex nut.
C. Join the two wire connectors together. See fig. 1. Make certain they are securely
connected.
D. Install bulb (not included). See relamping label located near socket area for type
and maximum allowed wattage.
E. Place upper ring onto bottom section of shade. See diagram for correct position.
F. Place glass plate inside of lower ring.
G. Lock upper ring onto lower ring by fastening with cap nut (decorative), from
below.
2. Install stems:
A. Choose desired installation height from dimensions shown in above diagram.
Thread fixture wires through each stems to be used. Note correct position of stems
from left diagram. Screw all stem together until secure.
B. Install bottom end of stem assembly by screwing into top of fixture.
C. Thread fixture wires through canopy and then swivel. Allow canopy to carefully
slide down without scraping the surface of stems. Then install swivel by screwing
onto top end of stem assembly.
3. Follow enclosed supplement installation instructions for electrical and fixture
installation onto house outlet box. If you do not have an outlet box at desired
location to attach the fixture than hire a qualified electrician to create one.
Assembly Instructions For
P1146
Cap Nut
Swivel
Canopy
(fixture plate)
Stem
Fig. 1
Lower Ring
Cap Nut
(Decorative)
Shade
Cover
Socket
Assembly
Glass
Tube
Upper
Ring
Bulb
(not included)
Fixture
Glass Plate
41-1/2"
29-1/2"
47-1/2"
23-1/2"
59-1/2"
35-1/2"
53-1/2"
17-1/2"
3
2
1E
1F
1G
1A
1B
1C
1D