Feiss OL3411 - Manual

(E) 3/05
M U R R A Y F E I S S
© MURRAY FEISS IMPORT LLC.
ASSEMBLY INSTRUCTIONS FOR OL3411
Machine Screw
Small Hex Nut
Fixture Plate
Ball Cap Nut
Canopy Loop
Adjustable
Chain Link
Adjustable
Chain Link
Fig. 1
CHAIN HUNG
INSTALLATION
Fig. 2
FLUSH MOUNT
INSTALLATION
Chain
Mounting Plate
Fixture Wires &
Ground Wire
Fixture Loop
Rubber Washer
Bulb
(not included)
Canopy
Threaded Pipe
Canopy
Loop
Fixture Wire &
Ground Wire
Ball Cap Nuts
Hex Nut &
Lock Washer
Mounting Plate
Machine Screw
Bulb
(not included)
Fixture Plate
Threaded Pipe
IMPORTANT
TURN OFF POWER AT MAIN FUSE OR CIRCUIT BREAKER
BOX BEFORE STARTING INSTALLATION
Carefully unpack and identify all parts before beginning
assembly. Bulb not included.
1 . Install light bulb (not included). See relamping label at socket area for
type and maximum allowed wattage.
2. This fixture can be mounted onto ceiling either as chain hung or
flush mount:
CHAIN HUNG INSTALLATION- Fig. 1:
A. Take fixture wire (with plastic insulation) and ground wire and
thread through rubber washer and fixture loop. Then install loop
onto threaded pipe located at top of lantern.
B. Determine the desired length of chain to hang. Remove any
unwanted links with chain pliers.
C. This fixture is supplied with 2 adjustable chain links. These links
are opened and closed by twisting cylinder on chain link. One
threaded chain link should be installed onto Fixture loop and the
other should be installed onto canopy loop. The standard chain
should be installed in between these 2 threaded chain links.
D. Take ground wire and weave through above chain links, then
thread through center hole in canopy loop. Repeat with fixture wire
(wire with plastic insulation).
FLUSH INSTALLATION- Fig. 2:
A. Remove and discard canopy loop and threaded pipe from
fixture plate.
B. Slip fixture plate, lock washer, and hex nut through fixture wires
and ground wire. Then install them onto threaded pipe by fastening
securely with hex nut.
3. Cut excess wires leaving only 6" (15cm) length of wires above
fixture plate. Split fixture wire into two strands. Then strip off
3/4" (19mm) of outer plastic insulation.
4. Follow enclosed “Fixture Installation Instructions” for electrical
and fixture installation onto ceiling outlet box.
Fig. 3
Twist to open or close chain link.
Threaded Chain Link