Bosch 4000 - Manual (Page 38)

38.
Basic Table Saw
Operation
Pre-Cut Locator
Allows you to mark and locate exactly where the blade will enter
the workpiece.
A . With the blade 90 degrees square to the table, cut off a piece
of wood 1. Always make sure you turn the saw off before
attempting step C.
B. Slide miter gauge 2 back until wood is over the yellow disc 3.
C. Using a very soft pencil, mark a line 4 on the disc 3.
D. Move the miter gauge to the other side of the blade and repeat
steps A, B, and C.
E. These lines indicate the “path” of the cut (kerf) made by the
blade.
90
30
45
60
75 75
60
45
30
FIG. 25
Using The Rip Fence Pointer
(only if table is not extended)
The rip fence shows the distance from the blade to rip fence
through a convenient viewing and magnifying window.
Align rip fence pointer 5 with lower portion of scale 6. The lower
scale can be used up to 13 inches (Fig. 26).
Using The Table Pointer
(only if table is extended to max.)
The upper portion of scale is used for rip cut 13 to 24-1/2 inches.
Align table pointer 7 with upper portion of scale 8 (Fig. 27).
Making Rip Cuts Beyond 24-1/2
Inches Without The Use Of Scale
When positioning fence for maximum rip without the use of scale
8, loosen screw 9 and lower plate 10 below the head 11 of the rip
fence 12 (Fig. 27). DO NOT rip or cut dados or moldings with the
fence beyond this position because it cannot be locked.
11 10 9 13 12 6 8 7
14 17 16 15 18 19
TABLE
POINTER 13
FENCE
FIG. 26
1
2
3
4
5
6