Feiss OL7808 User Manual

Assembly instructions for

Advertising
background image

IMPORTANT

TURN OFF THE POWER AT THE MAIN FUSE OR

CIRCUIT BREAKER BOX

BEFORE STARTING INSTALLATION

Carefully unpack and identify all parts before

assembly.

Bulbs not included.

1. Electrical installation onto post: If you are replacing an

existing fixture, disconnect and remove the old fixture.

A) Slip post cup over post. Mark position of holes in

post cup on post.

B) Remove post cup and expose the supply wiring

from above post. Drill 1/8" (3mm) diameter pilot holes

in post at places where marked.

C) Connect white fixture wire to white supply wire

from post with wire connector. Connect black fixture

wire to black supply wire from post with wire

connector.

NOTE: Black wire from post may be red, round and

smooth and/or have copper conductor. White wire

from post may be square and ridged and/or have a

silver conductor.

D) Connect fixture ground wire (without plastic

insulation) to ground wire from post (usually with

green insulation) with wire connector.

IMPORTANT: Never connect ground wire to black or

white supply wires.

E) Tuck all wires inside of post.

F) Slip post cup onto post. Align holes in post cup with

holes in post. Secure them together by fastening with

sheet metal screws (enclosed).

2. Slip candle tube onto sockets.

3. Install light bulb (not included). See relamping label at

socket area for type and maximum allowed wattage.

4. Slide glass shade, top cover, upper assembly, rubber

washer, neck, and spacer through threaded pipe. Then

lock them into position by fastening with finial.

Assembly Instructions For

OL7807, OL7808

(E) 12/10

3

2

4

1F

1C

1A

1D

1B

Advertising
This manual is related to the following products: