Feiss OL8508 - Manual

IIMPORTANT
TURN OFF THE POWER AT THE MAIN FUSE
OR CIRCUIT BREAKER BOX
BEFORE STARTING INSTALLATION
Carefully unpack and identify all parts before
assembly. Bulb not included.
1. Electrical installation onto post: If you are
replacing an existing fixture, disconnect and
remove the old fixture.
A) Slip post cup over post. Mark position of
holes in post cup on post.
B) Remove post cup and expose the supply
wiring from above post. Drill 1/8" (3mm)
diameter pilot holes in post at places where
marked.
C) Connect white fixture wire to white supply
wire from post with wire connector. Connect
black fixture wire to black supply wire from
post with wire connector.
NOTE: Black wire from post may be red,
round and smooth and/or have copper
conductor. White wire from post may be
square and ridged and/or have a silver
conductor.
D) Connect fixture ground wire (without
plastic insulation) to ground wire from post
(usually with green insulation) with wire
connector.
IMPORTANT: Never connect ground wire to
black or white supply wires.
E) Tuck all wires inside of post.
F) Slip post cup onto post. Align holes in
post cup with holes in post. Secure them
together by fastening with sheet metal
screws (enclosed).
2. Install light bulb (not included). See
relamping label at socket area for type and
maximum allowed wattage.
3. Install main frame onto top cover with
screws.
Assembly Instructions For
2
3
OL8507, OL8508
(E) 11/11
1F
1C
1A
1D
1B