Feiss WB1451 - Manual

IMPORTANT
TURN OFF THE POWER AT THE MAIN FUSE OR
CIRCUIT BREAKER BOX
BEFORE STARTING INSTALLATION
Carefully unpack and identify all parts before assembly. Bulbs
not included.
1. Install large glass plate:
Install large glass panel onto rear of fixture frame by bending
tabs.
2. Install anchor (included):
A. Hold mounting plate up against the wall aligning the two
holes in the wall outlet box with appropriate slots in the
mounting plate. Then while the mounting plate is leveled
vertically, use a pen or pencil to make a mark on the wall at
holes located near each end of mounting plate.
B. Remove the mounting plate and set aside.
C. Drill marked spots. If drywall or masonry wall then use
1/4" (7 mm) drill bit; if wood wall then use 1/8" (4 mm) drill
bit.
D. Drywall or masonry wall only: Insert plastic anchor into
pre-drilled holes.
3. Install mounting plate:
A. Take supply wires from outlet box and carefully pass them
through center hole of mounting plate. Note: the flat surface
of mounting plate must face the wall and the angled rim side
facing toward you.
B. Install mounting plate to outlet box using two screws
supplied with the outlet box.
C. Secure mounting plate onto pre-drilled holes using sheet
metal screws (included).
D. Then Spread electrical wires so that black wires are on
one side of the outlet box and the white wires are on the
other side.
4. Connect electrical wires:
A. Connect white fixture wire(s) to white supply wire from
outlet box with wire connector. Connect black fixture
wire(s) to black supply wire from outlet box with wire
connector.
NOTE: Black outlet box wire may be red, round and smooth
and/or have copper conductor. White outlet box wire may
be square and ridged and/or have a silver conductor.
B. Connect fixture ground wire (without plastic insulation)
to ground wire from outlet box (usually with green
insulation) with wire connector.
Note: If there is no supply ground wire at outlet box then
attach fixture ground wire securely onto green grounding
screw located at mounting plate.
IMPORTANT: Never connect ground wire to black or white
supply wires (from outlet box).
5. Install fixture:
A. Hook top of fixture frame onto top edge of mounting
plate.
B. Then secure fixture frame onto bottom of mounting plate
by fastening set screws. Use provided hex key to tighten.
6. Install bulb:
A. Rotate housing until inside socket is exposed.
B. Install type T-10 of medium base light bulb (not included).
IMPORTANT: See relamping label at socket area for
maximum allowed wattage.
C. Install small glass plate by sliding inside of housing.
D. Rotate housing to desired position. Note: You have the
option to either direct or indirect light by turning the
housing accordingly.
Warning: Shade becomes HOT. Do not rotate shade while
fixture is lit. Turn off and allow shade to cool before rotating
into desired position.
Assembly Instructions For
WB1451
(E) 5/09
2
1
4
5A
6B
6C
3C
3D
5B
6A
6D 3B
3A