Grill controls – Garland XG36CE BE/FR MASTER SERIES GAS XPRESS GRILL User Manual
Page 10
Part # 4517129 Rev.1 (03/10/10)
Page 10
GRILL CONTROLS
Master Power Switch:
Controls power to the grill and must be turned “ON” to start
operation. The controller display will be active when the
switch is “ON”.
LED Indicators:
There are two, (2), indicator lights, indicating the
temperature status of each control’s heat zones; one, (1), on
the upper platen, (top light), and one, (1), on the grill surface.
Each light can display three, (3), different colors, indicating
temperature status for the corresponding zone.
Red: The zone is too hot, (more than 79°F/45°C over the set
temperature), or heat zone failure.
Amber: The zone is calling for heat.
Green: The zone is at or above the set temperature.
Display:
The controller display will contain information relevant to
each operation in both cook and program modes.
Product Buttons (0-9):
Buttons 0-9 can be assigned to product items. Buttons 9 and
0 are used to move the cursor left or right when creating
or modifying product names in “PROD NAME LIB” program
mode.
Power Button:
After the main power switch is turned on, this button will put
the control into cook mode. If pressed again, the control will
go back to displaying “OFF.”
PRODUCT
BUTTONS
DISPLAY
LED
INDICATORS
POWER
BUTTON
PROGRAM
BUTTON
TEMPERATURE
BUTTON
ENTER
BUTTON
DOWN ARROW
BUTTON
UP ARROW
BUTTON
WHEN PUSHED SIMULTANEOUSLY:
"START COOK TIME COUNTDOWN" (flat grill cooking)
OR "LOWER PLATEN" (two-sided cooking)
MASTER
POWER
SWITCH
CANCEL/
RAISE PLATEN
BUTTON
Program Button:
The primary function is to access Programming and
Calibration of the grill. Push and hold for five (5) seconds.
Display will ask for the code. After entering code, five
programming features will be accessible “MENU ITEMS,”
“SYSTEM INFO,” “SYSTEM SETUP,” “SERVICE MODE,” and
“PRODUCT NAME LIB.”
Temperature Button:
In the Cook mode, each time the button is pressed the
current temperature for one zone is displayed. The grill
temperature is displayed first followed by the platen
temperature. After five (5) seconds, the display will return to
the menu item selected.
Up/Down Arrow Buttons; 2 Functions:
1. In the cook mode, the Up/Down Arrow Buttons will cycle
through the different menu items.
2. In the program mode, the Up/Down Arrow Buttons will
change the value of the current setting.
Enter Button:
Function is to accept programming steps.
Cancel/Raise Platen Button, (Green):
During the cooking cycle, pressing this button will cancel the
cooking timer and return the grill to the “IDLE” mode. This
button will also bring the grill out of STANDBY.
Black Button:
When both Black and Green “CANCEL/RAISE” buttons are
pressed simultaneously, the upper platen will lower to the
griddle surface.