Garland XG36CE BE/FR MASTER SERIES GAS XPRESS GRILL - Manual (Page 11)

Part # 4517129 Rev.1 (03/10/10) Page 11
OPERATION
Installing Release Material:
Slide release material rod through hemmed end of the
release material sheet.
Hook release material rod on brackets located at the rear of
the upper plate
UPPER PLATEN (side view)
RELEASE MATERIAL HOOK
RELEASE MATERIAL SHEET
RELEASE
MATERIAL ROD
REAR OF GRILL
Holding the bottom of the release material sheet in place,
gently pull the sheet toward the front of the platen.
Thread the front edge of the release material sheet behind
the release material bar on the front of the platen, then
around the top and down over the front of the bar as shown.
Place locking clips over release material sheet and press into
place over release material bar.
RELEASE
MATERIAL
LOCKING
CLIP (1)
RELEASE
MATERIAL
BAR
RELEASE
MATERIAL
UPPER PLATEN (side view)
FRONT OF GRILL
Check alignment and tightness of release material against
upper platen.
NOTE: Make sure release material fits smoothly over upper
platen. Installing release material sheets too tight may cause
premature failure of the sheet.
Release sheets are reversible and should be flipped
over and reattached on a daily basis. For instructions on
cleaning release sheets; see Step 17, in daily cleaning, under
CLEANING AND MAINTENANCE section.
A release material sheet must be replaced when:
• Product sticks to release material.
• Carbon build-up causes problems in taste or appearance.
• Tearing occurs in the sheet’s cooking area.
• Release material coating is worn off sheet.