Garland G SERIES INFRA-RED SALAMANDER BROILERS - Manual (Page 13)

Part # 4523916 Rev 2 (05/05/14)
Model GIR60 – 60” Ranges
Page 13
INSTALLATION Continued
DETAIL
II
DETAIL
I
60" RANGE
Figure 3 – With area detail defi ned for 60 inch range.
NOTE: Instructions are for mounting the salamander on the
right side, for mounting on the left side follow the same
directions except use references 1, 2, 3, & 4 (to the left of
detail II see below) in lieu of A, B, C, D for detail II in the
following steps.
3 4 C D
DETAIL
II
1 2
A B
1. Remove screws from back of oven on both sides of the
range (detail I) and center (detail II) as shown:
REMOVE
2 SCREWS
FROM BOTH SIDES
DETAIL I
ALL 60" MODELS
A
A
B
B
C D
C D
DETAIL II
FOR 60" RANGES
WITH STANDARD OVEN
DETAIL II
FOR 60" RANGES
WITH CONVECTION OVEN
REMOVE
2 SCREWS
IF REQUIRED
REMOVE
2 SCREWS
IF REQUIRED
REMOVE
2 SCREWS
IF REQUIRED
REMOVE
2 SCREWS
IF REQUIRED
2. Install the left and right support brackets (part # 4523226
and 4523227) using the 2 screws removed in step 1
(detail I) and one additional screw on both sides of the
range, and center support bracket (part # 4523282) with
the four screws removed in step 1 (detail II).
INSERTED
SCREWS
DETAIL I
ALL 60" MODELS