Garland HO1500 INDUCTION TEMPERATURE CONTROLLED TABLETOP HOLD-LINE - Manual (Page 17)

Operating Instructions RTCSmp Tabletop Temperature Controlled Hold-Line
Part # 4532289 Rev 2 (1/17/14) 17
Digital Display:
• Temperature followed by a dot: When you turn the control knob, the digital display shows
the selected temperature followed by a dot. Within 2 seconds, the display will show the actual
temperature.
• Temperature followed by a blinking dot: The blinking dot indicates the induction zone is
active and the current temperature is displayed. This means the system has detected a pan in the heating
zone and energy is being transferred to the pan.
• Temperature without a dot: The display shows the actual temperature and the induction coil
is dormant. This means no energy is being transferred.
• To shutdown the unit, simply turn the ON/OFF switch to the OFF-position.
NOTE If you are using both heating zones at the same time, note that power is cycled from one zone to
another. This means when the left zone is active and the dot blinks, the right zone is dormant and its
temperature is shown without a dot, and vice versa. This is normal.
6.4 No Pan No Heat
When a temperature is selected, the induction unit only transmits energy when a pan is placed in the heating
zone. If you remove the pan from the heating zone, power transfer to the pan stops immediately. If the pan is put
back in the heating zone, power is transferred to the pan again.
Note that pan with a bottom diameter smaller than 5”(12 cm) is not detected by the system.
After switching the unit off, there is no heat retained inside the unit.
6.5 When Unit is Not In Use
Best Practice: If the induction unit is not in use, ensure the ON/OFF switch is in the 0 (OFF) position.
• Switch the unit OFF if you take the cookware away for a while. This will prevent the heating process to
start automatically and unintentionally when a pan is placed back on the heating area. If any person
needs to use the induction unit, he/she will have to turn the unit ON intentionally.