General Machine Products 89910 Whisper Micro Fiber Cable Blowing Machine - Manual (Page 12)

Page 12 General Machine Products Co., Inc.
Outfitting the Whisper
When preparing the Whisper for use, you must know the OD of the cable being blown and the
size of the duct you are blowing in.
Preparing the Whisper for the proper cable size
Measure the OD of the cable.
Select the corresponding cable collet assembly for the size cable you’re blowing
Install Cable Seal Collet Components into the Whisper
A. Install infeed guides
Install infeed guide by removing the two screws retaining the top
block of the infeed guide holder. Secure the top and bottom
guide halves with their retaining screws. Reattach the top block
of the infeed guide holder.
B. Install Cable Guide
CABLE SEAL COLLET
ASSEMBLY
89930 2.0 - 2.5 mm
89931 2.5 - 3.0 mm
89932 3.0 - 3.8 mm
89933 3.8 - 5.0 mm
89934 5.0 - 6.4 mm
89935 6.4 - 8.5 mm
Tighten the two screws re-
taining the top plate of the
air-box in-feed guide.
Tighten the mounting screws. Place the guide in the
grove on the exit side of
the roller