General Machine Products 89910 Whisper Micro Fiber Cable Blowing Machine - Manual (Page 15)

Page 15 General Machine Products Co., Inc.
Fit the cable through the machine.
Pass the cable through the in-feed guide clamp, through
the gap between the drive rollers. Continue to feed the ca-
ble through the cable seal into the airbox and into the duct.
Tighten the clamping screw until it bottoms out and then back
off two complete turns for most cables. Some cables may re-
quire less clamping due to their size or construction. The
amount of compression required will become clear as more
experience is gained with the machine.
See appendix 2 for more information.
The roller tension is now set.
Back off the clamping
screw turning CCW far
enough to fit the cable
between the rollers.
The cable is now positioned in the machine.
Tighten the airbox chamber/duct clamp-
ing screw tightly.