General Machine Products 89300 AirStream Cable Blowing Machine User Manual
Page 15
Page 15 of 44
Connect the air supply to the machine.
The air inlet to the machine is male via a crowfoot coupling on the back of the airbox. An on/off valve is fitted to
the air box to provide control of the air supply to the operator and a pressure gauge is fitted to the air box to
indicate air box pressure. Maximum safe working pressure is 15 Bar ( 210 psi).
Connect the electrical supply to the
machine.
Note: Please refer to Section 4.0 Specification for details
on power supply quality. General Machine Products Co.,
Inc. recommend the use of a Honda EU1000i generator.
The transformer accepts voltages between 100-277 Vac
50/60Hz automatically. Adaptors are available to suit any
required existing connector, speak to our sales department
for full details and specification of connector.
If the power supply lead supplied with the AirStream Cable Blowing Machine is unsuitable and requires to be
changed refer to the safety instructions for further details.
IT IS THE RESPONSIBILITY OF THE USER TO ENSURE THAT THE CONNECTIONS MEETS THE
ELECTRICAL REGULATIONS FOR THE RELEVANT COUNTRY.
The machine is now ready to start the cable installation.