General Machine Products 89300 AirStream Cable Blowing Machine - Manual (Page 21)

Page 21 of 44
The machine should be returned to the manufacturers (or an approved service agent) after every 1000 hours
use (or at intervals of 12 months) for a major service. The service will include the following.
• Strip down the machine.
• Clean and inspect all parts for damage, replace as necessary.
• Check all screws and fasteners for damage, replace as necessary.
• Check all bearings for smooth running, replace as necessary.
• Check all electrical connections for continuity and damage, remake connections and/or replace connectors
as necessary.
• Check all air box connections and insert settings. Replace any badly damaged parts which compromise
sealing integrity as necessary.
• Check / Replace lower housing seals.
• Check / Replace the drive shaft seal housing “O” rings.
• Rebuild the machine, to current build standard.
• Test.