INFICON Ecotec E3000 Multigas-Sniffer-Leak Detector Interface description - Manual (Page 17)

3 RS-232 interface
17
In
te
rface D
e
scr
ipti
o
n
Ecotec E300
0,
k
ins
22e1
-j
, 1401
3.2.2 List of Commands
The following table lists all commands available in the ASCII mode.
Table 11: List of commands, ASCII
Command

word1
Command

word2
Command

word3
Statement Read/Set
*CAL external calibration -
:ESC escape S
:FACtor calibration factor R
:NEW actual calibration factor R
:OLD last calibration factor R
:FLOW flow at calibration R
:NEW flow at actual calibration R
:OLD flow at last calibration R
:LEAKrate leak rate (test leak) R/S
:POSition mass position R
:NEW mass position at actual calibration R
:OLD mass position at last calibration R
:QUIT acknowledge (proceed) S
:READ signal (for stability observation) R
:SELect gas selection (1 … 4; only enabled gases) R/S
:START start (switch from PROOF to CAL S
:STATus Status (plain text)

“T<20MIN, CONFIRM”

“SELECT GAS”

“START CAL, CONFIRM”

“EDIT LEAKRATE”

“LEAK STABLE, CONFIRM”

“AIR STABLE, CONFIRM”

“PROOF FINISHED, CONFIRM”

“PEAK (xx), CONFIRM”

“ERRxx, CONFIRM”

“WAIT”

“REMOVE SNIFFER”
R
:UNIT unit (test leak) R/S
*CLS clear error R
*CONFig
:AUDio audio alarm type (TRIGger, SETpoint, PINpoint) R/S
:AUDIOType type trigger / alarm (1, 2, 3) R/S
:BAUD baudrate ASCII mode (1200, 2400, 4800, 9600,
19200) R/S
:BEEP beep-sound (ON, OFF) R/S
:BRIGHTness sniffer light brightness (1 … 6) R/S
:CALAccess CAL enable (ON, OFF) R/S
:CONTrast contrast of main display (0 …99) R/S
:CONTROL control location (LOCAL, RS232, LOCAL/RS232) R/S
:DELay alarm delay (0.0 … 9.9) [s] R/S