INFICON Ecotec E3000 Multigas-Sniffer-Leak Detector Interface description - Manual (Page 19)

3 RS-232 interface
19
In
te
rface D
e
scr
ipti
o
n
Ecotec E300
0,
k
ins
22e1
-j
, 1401
:SELect gas select (Auto, Manu, Hold) R/S
:SELTime Gas select time (5, 10, 15, 20) R/S
:SENSitivity sensitivity check (ON, OFF) R/S
:SNIFFer Audio sniffer (off, TRIGger SEARch)

(for compatibility TRIGger
 on)
R/S
:SPEAker audio speaker internal (ON, OFF) R/S
:UNIT pressure unit (Torr, mbar, atm, Pa) R/S
:VOLMin minimum volume (0 … 15) R/S
:VOLume volume (0 … 15) R/S
:WAKEup :1 … :7

:MON, :TUE…
WakeUp (hh:mm, 00:00
 disable)
1-Monday, 2-Tuesday, …
R/S
:WARNreminder warning reminder (ON, OFF) R/S
:ZERO ZERO (ON, OFF)

sniffer line and main unit affected
:ZEROSniff ZERO sniffer line (ON, OFF) R/S
:ZEROMain ZERO via main unit (ON, OFF) R/S
:ZEROTime ZERO time (1.0 … 9.9) R/S
*GAS:<no> 1 … 4 gas number (1 … 4)
:CALFAC calibration factor R
:CALintern Internal calibration

enable: on, 1, ENAble

disable: off, 0, DISable

(depends on selected mass)
R/S
:CONFig Configuration selected mass position 1, 2, … 5

(depends on masses and factor)
R/S
:CORRfac Correction factor (The correction factor is calculated
from the other settings) R
:EQUIname Equivalent gas name

(Equivalent gas only possible, if He/H2 mass 2/4 is
selected. If an equivalent gas name is set, the viscosity
is loaded from the RomLib.
R/S
:FACTOR Factor to the mass positions (5)

(example: 0.72, 0.46, 0.12, 0.0, .0.)
R
:GASpress Equivalent gas pressure [bar] R/S
:HEpress Pressure (He / H2) [bar] R/S
:LASTcal last calibration (Date, Time, Internal / External) R
:LIMIT Lower display limit (1, 2, 5, 10, 20, 50, 100)
:LRlimit Lower display limit (leak rate) R
:MASS mass position [amu] ± deviation [amu] R
:MASSES possible mass positions (5)

(example: 69, 83, 51, 0, 0) (R600a IGS on position 5)

Notice: Changing this setting will clear the calibration
data!
R/S
Table 11: List of commands, ASCII (cont.)
Command

word1
Command

word2
Command

word3
Statement Read/Set