INFICON SQC-122 Thin Film Deposition Controller Communications Manual - Manual (Page 6)

1318 Duff Drive
?
Fort Collins, Colorado 80524
?
(970) 416-9660
?
Fax (970) 416-9330
?
Sigma
instruments
After the flag is read, it is reset and will not be set again until the unit is
power cycled.
Example: Y A1 Power-Up Reset flag is set.
Y A0 Power-Up Reset flag is reset.
Command: Z
Parameters: None.
Description: Set all Film and System parameters to defaults.
Note that this command can take over 1 second to complete
Example: Z A All Film and System parameters are set to defaults.