Intelix DIGI-88B - Manual (Page 12)

DIGI-88B Installation Guide
IR Remote Code
The IR remote includes a System Code Switch that will allow you to toggle
between two [2] command sets. This is useful for locations where two
DIGI-88B units are installed.
1. Press the System Code Switch button three times in quick
succession. This will change the remote from the default (x00)
command set to the alternate (x04) command set.
2. Press the System Code Switch button three times in quick
succession to toggle back to the default (x00) command set.
3. The matrix will respond to either command set.
12