JUMO 706560 LOGOSCREEN es Operating Manual - Manual (Page 92)

4 Configuration parameters
92
Address
(21 (Profibus-DP)) Configuration
➔ Interfaces
➔ 21 (Profibus-DP)
➔ Address
1 — 125 — 127 Setting the address from
which the recorder can be
addressed in the Profibus-
DP network.
Baud rate
(21 (Profibus-DP)) Configuration
➔ Interfaces
➔ 21 (Profibus-DP)
➔ Baud rate
The baud rate is
automatically set by the
PROFIBUS-DP master.
Measurement
normalization
(21 (Profibus-DP)) Additional parameters for measurement normalization of the internal analog inputs
are configurable through the setup software. Further information can be found in the
Operating Instructions B 70.6560.2.3 (Interface description PROFIBUS-DP).
22 (Ethernet) Configuration
➔ Interfaces
➔ 22 (Ethernet)
Setting the parameters for
Ethernet interface.
IP address
(22 (Ethernet)) Configuration
➔ Interfaces
➔ 22 (Ethernet)
➔ IP address
0.0.0.0 — 255.255.255.255 IP address of
recorder
Subnet mask
(22 (Ethernet)) Configuration
➔ Interfaces
➔ 22 (Ethernet)
➔ Subnet mask
0.0.0.0 — 255.255.255.255 Subnet mask
Gateway
(22 (Ethernet)) Configuration
➔ Interfaces
➔ 22 (Ethernet)
➔ Gateway
0.0.0.0 — 255.255.255.255 Gateway address to which
the recorder is connected.
Parameter Value/selection Description