Kinetik Blood Pressure BPM1KTL - Manual (Page 5)

Setting up your Blood Pressure Monitor
Loading Batteries
a. Open the battery cover on the base of the monitor.
b. Insert four “AAA” batteries, observing correct polarity.
c. Close the battery door.
•
Non-rechargeable batteries are not to be recharged.
•
Exhausted batteries are to be removed from the monitor.
•
The supply terminals are not to be short circuited.
•
Do not mix old and new batteries or different types of
batteries. Do not use rechargeable batteries. Only batteries
of the same or equivalent type as recommended are to be
used. Batteries must be handled with care under adult
supervision. If batteries leak and come into contact with
skin or eyes, wash immediately with copious amounts
of water.
Connecting the Cuff
a. Insert the plug end of the rubber tubule firmly into
the cuff socket located on the front of the monitor
to ensure there is no air leakage.
Replacing Batteries
•
When the LCD screen displays ‘low battery’
new batteries must be inserted immediately
to ensure accurate results.
•
Please dispose of batteries according to battery
manufacturer’s instructions.
b. The cuff should be ready to use. Ensure that the end is passed
through the metal loop and the hook and loop fastening is facing
outwards. NOTE: Cuff supplied.
BPM1KTL
fully automatic BLOOD PRESSURE MONITOR
memory / select
start
IHB