Kinetik Blood Pressure BPM1KTL - Manual (Page 6)

Setting up your Blood Pressure Monitor
Clock and Date Adjustment
5
a. Once you install the battery or turn off the monitor, it will enter
standby mode, and LCD will alternate between time and date.
b. While the monitor is in standby, press and hold both the ‘start’ and ‘memory’ buttons
simultaneously until the green backlight comes on and the month digit starts to blink.
Press the ‘memory’ button repeatedly (or press and hold for rapid advance) to select
the correct month. Once done, press the ‘start’ button to confirm. The month is now
set and you can begin to select the correct day, again using the ‘memory’ button to
select and the ‘start’ button to confirm. Repeat the procedure for setting the hour and
minutes. When finished, the monitor will return to standby mode.
c. The monitor will turn off automatically after 1 minute of no operation, with the time
and date unchanged.
d. Once you change the batteries, you should readjust the time and date.
Note: when you adjust the clock and date, the backlight always is green.