Wing roller axle installation – Landoll WFPC38-52 Wing Float Pulverizer User Manual
Page 31
Advertising
ASSEMBLY
2-17
Wing Roller Axle Installation
Attach a Roller Axle Assembly to each Wing Frame.
The Trunnion Bearing Grease Fitting should be oriented
towards the rear of machine.
NOTE
Roller Axle Assembly clamped end must be on the outer
extremity of the Wing.
Figure 2-14: Wing Roller Axle Installation, 38 ft - 46 ft
WFP38-46OpWingRoller
Trunnion Washer
Trunnion Bearing Mount
HHCS,3/4-10 x 2 1/4
3/4” Lock Washer
Bearing Hanger
Bearing Hanger
Clamp
5/8” Flange Nut
HHCS,5/8-11 x 7”
FRONT
Washers located between
Bearings and Rear Mounts.
Bearing Grease fitting must be
oriented to the rear of the machine.
Advertising
This manual is related to the following products: